KitchenAid 18.5 cu. ft. 29 5/8" Width Right-Hand Door Swing Architect® Series II 使用とお手入れ

■

Is the water pressure at least 35 psi (241 kPa)? The water 
pressure to the home determines the flow from the dispenser. 
See “Water Supply Requirements.”

■

Water filter installed on the refrigerator? Remove filter and 
operate dispenser. If water flow increases, the filter may be 
clogged or incorrectly installed. Replace filter or reinstall it 
correctly.

■

Refrigerator door closed completely? Close the door firmly. 
If it does not close completely, see “The doors will not close 
completely.”

■

Recently removed the doors? Make sure the water 
dispenser wire/tube assembly has been properly reconnected 
at the bottom of the refrigerator door. See “Refrigerator 
Doors.”

■

Reverse osmosis water filtration system connected to 
your cold water supply? This can decrease water pressure. 
See “Water Supply Requirements.” 

NOTE: One or two drops of water after dispensing is normal.

■

Glass not being held under the dispenser long enough? 
Hold the glass under the dispenser 2 to 3 seconds after 
releasing the dispenser lever.

■

New installation? Flush the water system. See “Water 
Dispenser.”

■

Recently changed water filter? Flush the water system. See 
“Water Dispenser.”

■

Water on the floor near the base grille? Make sure the water 
dispenser tube connections are fully tightened. See 
“Refrigerator Doors.” 

NOTE: Water from the dispenser is only chilled to 50°F (10°C).

■

New installation? Allow 24 hours after installation for the 
water supply to cool completely.

■

Recently dispensed large amount of water? Allow 24 hours 
for water supply to cool completely.

■

Water not been recently dispensed? The first glass of water 
may not be cool. Discard the first glass of water.

■

Refrigerator connected to a cold water pipe? Make sure 
the refrigerator is connected to a cold water pipe. See “Water 
Supply Requirements.”