KitchenAid 1.8 cu. ft. Capacity 1,000 Watts Architect® Series II インストールガイド

5. Rotate blower motor end over end.

6. Rotate blower motor so that exhaust ports face the back of 

microwave oven, and lower blower motor back into the 
microwave oven.

7. Reattach blower motor to back of microwave oven with 

2 screws removed in Step 3.

8. Reattach damper plate. Make sure tabs at top and back of 

damper plate are inserted fully into their respective slots in the 
microwave oven

.

9. Secure damper plate with screw.

1. Repeat Step 1 from “Wall Venting Installation Only.”
2. Repeat Step 2 from “Wall Venting Installation Only.”
3. Repeat Step 3 from “Wall Venting Installation Only.”
4. Repeat Step 4 from “Wall Venting Installation Only.”
5. Rotate blower motor so that exhaust ports face the top of 

microwave oven, and flat sides of blower motor face back of 
microwave oven. Lower blower motor back into microwave 
oven.

IMPORTANT: If blower motor is not positioned with flat sides 
facing the back of the microwave oven (as shown), performance 
will be poor.
6. Reattach blower motor to back of microwave oven with 

2 screws removed in Step 3 of “Wall Venting Installation Only.” 
Securely tighten screws.

NOTE: If blower motor is not correctly oriented, the 2 screws 
removed in Step 3 cannot be reattached to the microwave oven.
7. Reattach damper plate. Make sure tabs at top and back of 

damper plate are inserted fully into their respective slots in the 
microwave oven.

8. Secure damper plate with screw.

A

A            B C                   D   E

A

A            B C                   D   E