KitchenAid 24" Wall-Mount Canopy インストールガイド

ページ / 28
11
RANGE HOOD CARE
Cleaning
IMPORTANT: Clean the hood and grease filters frequently 
according to the following instructions. Replace grease filters 
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool or 
soap-filled scouring pads. 
Always wipe dry to avoid water marks.
Cleaning Method:
Liquid detergent soap and water, or all-purpose cleanser
Wipe with damp soft cloth or nonabrasive sponge, then rinse 
with clean water and wipe dry.
Metal Grease Filter:
1. Remove each filter by pulling the spring release handle and 
then pulling down the filter. 
2. Wash metal filters as needed in dishwasher or hot detergent 
solution.
3. Reinstall the filter by making sure the spring release handles 
are toward the front. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch into place.
6. Repeat steps 1-5 for the other filter.
Non-Vented (recirculating) Installation Filters:
The charcoal filter is not washable. It should last up to 6 months 
with normal use. Replace with Charcoal Filter Kit. See the 
“Accessories” section for information on ordering.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See “Metal 
Grease Filter” in this section.
2. Bend spring clips away from metal grease filter. 
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the charcoal filter 
to the metal filter. 
5. Replace metal grease filter. See “Metal Grease Filter” in this 
section.
Replacing a Halogen Lamp
Turn off the range hood and allow the halogen lamp to cool. To 
avoid damage or decreasing the life of the new lamp, do not 
touch lamp with bare fingers. Replace lamp, using tissue or 
wearing cotton gloves to handle lamp.
If new lights do not operate, make sure the lamps are inserted 
correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver and gently pry the light cover 
loose.
3. Remove the lamp and replace with a 12-volt, 20-watt 
maximum, halogen lamp made for a G-4 base.
4. Replace the light cover.
5. Reconnect power.
A. Spring release handle
A