KitchenAid 30-Inch 4 Burner Gas Rangetop, Commercial-Style インストールガイド

 

■

If local codes permit, a new CSA design-certified, 4-5 ft 

(122-152.4 cm) long, 

5

/

8

" (1.6 cm) or 

3

/

4

" (1.9 cm) I.D. 

(inside diamter), flexible metal appliance connector may 

be used for connecting the cooktop to the gas supply 

line.

 

■

A 

1

/

2

" (1.3 cm) male pipe thread is needed for connection 

to the female pipe threads of the inlet to the appliance 

pressure regulator.

 

■

Do not kink or damage the flexible metal tubing when 

moving the cooktop.

 

■

Must include a shut-off valve: 

The supply line must be equipped with a manual shut-off 

valve. This valve should be located in the same room but 

external to the cooktop enclosure or cabinet. It should be in 

a location that allows ease of opening and closing. Do not 

block access to shut-off valve. The valve is for turning on or 

shutting off gas to the cooktop.

The gas pressure regulator supplied with this cooktop must 

be used. The inlet pressure to the regulator should be as 

follows for proper operation:
Natural Gas:
Minimum pressure: 6" (15.2 cm) WCP
Maximum pressure: 14" (35.5 cm) WCP
LP Gas:
Minimum pressure: 11" (27.9 cm) WCP
Maximum pressure: 14" (35.5 cm) WCP
Contact local gas supplier if you are not sure about the inlet 

pressure.

Input ratings shown on the model/serial rating plate are for 

elevations up to 2,000 ft (609.6 m).
For elevations above 2,000 ft (609.6 m), ratings need to be 

reduced at a rate of 4% for each 1,000 ft (304.8 m) above 

sea level (not applicable for Canada).

Gas supply pressure for testing regulator must be at least 

1" water column pressure above the manifold pressure shown 

on the model/serial/rating plate.
Line pressure testing above 

The cooktop and its individual shut-off valve must be 

disconnected from the gas supply piping system during any 

pressure testing of that system at test pressures in excess of 

1

/

2

 psi (3.5 kPa).

The cooktop must be isolated from the gas supply piping 

system by closing its individual manual shut-off valve during 

any pressure testing of the gas supply piping system at test 

pressures equal to or less than 

1

/

2

 psi (3.5 kPa).

INSTALLATION INSTRUCTIONS

Install Cooktop

Write down the model and serial numbers before installing the 

cooktop. Both numbers are located on the left front underside 

of the burner base.
Unpack the parts supplied with your cooktop. The parts shipped 

with the cooktop depend on your model ordered. See the “Tools 

and Parts” section for a complete list parts supplied with your 

cooktop.

The pressure regulator and flexible stainless steel gas supply 

line connector can be assembled to the cooktop now or after 

the cooktop is installed in the cutout. See the “Make Gas 

Connection” section.
1.  Decide on the final location for the cooktop.
2.  Using two or more people, place the cooktop upside down 

on a covered surface.