KitchenAid 22.7 Cu. Ft. Counter Depth Side-by-Side Refrigerator with Exterior Ice and Water 使用とお手入れ

2. Press and hold the OPTIONS and LOCK buttons at the same 

time for 3 seconds. The words “Back” and “1 Cup” will appear 
on the display screen. 

3. Using your hand (not the measuring cup), press and release 

the water dispenser pad in order to dispense water to the 
1 cup fill line. 

NOTE: If overfilling or spilling occurs, discard the water and 
press “Back” to restart the calibration process.

4. When 1 cup of water has been correctly dispensed into the 

measuring cup, press the MEASURED FILL button under the 
word “Confirm” to confirm the calibration.  

When Measured Fill calibration has been confirmed, the display 
will return to the home screen.

■

Dispense at least 1 qt (1 L) of water every week to maintain 
a fresh supply.

■

If the flow of water from the dispenser decreases, it could 
be caused by low water pressure.

■

With the water filter removed, dispense 1 cup (237 mL) of 
water. If 1 cup of water is dispensed in 8 seconds or less, 
the water pressure to the refrigerator meets the minimum 
requirement.

■

If it takes longer than 8 seconds to dispense 1 cup of 
water, the water pressure to the refrigerator is lower than 
recommended. See “Water Supply Requirements” or 
“Troubleshooting” or “Problem Solver” for suggestions.

1. Press a sturdy glass against the water dispenser pad. Hold 

the glass close to the water dispenser spout to ensure that 
the water dispenses into the glass.    

NOTE: While dispensing water and for 3 seconds after 
dispensing has stopped, the digital display will show how 
much water has been dispensed.

2. Remove the glass to stop dispensing.

Measured Fill allows you to dispense a specified amount of water 
with the touch of a few buttons. 
NOTE: The amount of water you select will be dispensed. Be sure 
that the container is empty and can hold the entire volume. If ice is 
in the container, you may need to adjust your selection.
IMPORTANT: Low water pressure may affect the accuracy of this 
feature.
1. Press MEASURED FILL to turn the feature on. When the 

feature is on, the Measured Fill screen appears on the display. 

Press ICE MODE to manually turn off the Measured Fill 
feature.

NOTE: The dispenser will automatically turn off Measured Fill 
after 1 minute of inactivity. When Measured Fill is turned off, 
any changes you have made will be lost and all defaults will be 
restored.

2. You can dispense water by the ounce, cup, or liter. The default 

unit is ounces. To switch to cups or liters, press the LIGHT 
button.
Default, minimum, and maximum volumes are listed below.

3. Press the LOCK and OPTIONS buttons to adjust the volume 

as desired. The LOCK button increases the volume, and the 
OPTIONS button lowers the volume.
NOTES: 

■

When increasing or decreasing the volume, the control 
may stop responding if an adjustment button is held for 
approximately 10 seconds or longer. Release the button 
for approximately 2 seconds, then continue making 
adjustments.

■

Most coffee cups (commonly 4 to 6 oz [118 to 177 mL] 
per cup) are not the same size as a measuring cup (8 oz 
[237 mL]). You may need to adjust the volume to avoid 
unintentionally overfilling coffee cups.

A

Ounces

8

1

128

Cups

1

¹/₄

16

Liters

0.25

0.05

4.00

Calibrate Measured Fill