Xerox 2101 ST Digital Copier/Printer インストールガイド

The diagrams on the following pages show typical systems you can use to print and run 
Fiery software from remote workstations. Find the page with your preferred platform 
and network type, and then look up the setup procedures referenced in the “Key to 
setup” in the upper-left corner of each diagram. 

The diagrams describe devices that use the supported networking protocols. They are 
logical diagrams and are not intended to describe the physical arrangement (topology) 
of devices on the network. A variety of physical arrangements is possible with each 
logical arrangement. For example, twisted pair Ethernet networks commonly use a star 
configuration around a hub, rather than a bus arrangement. The design of physical 
networks is beyond the scope of this manual.

If your network uses more than one protocol or more than one type of workstation, 
combine the setups listed for each component of your system. Multiple protocols 
(shown in the diagrams as parallel lines) can run on the same cable. A solid connection 
from the Fiery EX2101 with an arrow indicates that other supported network types 
can be operational at the same time. 

The protocols used in these diagrams are indicated as follows: