Xerox 2101 ST Digital Copier/Printer インストールガイド

 

This chapter describes the procedures for installing the EX2101 software and setting 
up printing from a computer using a supported version of Windows. For Windows 
versions supported, see the

 

The general steps for installing the software are as follows: 

• Install the PostScript printer driver or PCL printer driver and corresponding printer 

driver files, and set up the printer driver to communicate with the Fiery EX2101.

• Install Fiery utilities and user software—Fiery Downloader, Fiery VDP Resource 

Manager, Fiery Spooler, EFI Job Monitor, Fiery Printer Delete Utility, Hot Folders, 
and Command WorkStation.

• Configure the connection for Fiery utilities and user software.

• Copy additional files from the User Software CD as required.

 

To set up the Fiery EX2101 as a PostScript or PCL printer, you must install the 
PostScript or PCL printer driver for Windows 98/Me and the corresponding printer 
description files. You must also configure either a local connection for printing directly 
or a network connection for printing over the network. 

 

Using the PostScript driver requires either the hard disk option or the PostScript 

option installed on the copier.

If you are printing using SMB (Server Message Block), you can connect to the 
Fiery EX2101 and install the printer drivers in a single procedure. For more 
information, see