Xerox Document Workstation with PlotWorks Support & Software ユーザーガイド
PlotWorks User Guide • The Job Editor • 4-117
Example: If the destination is using LAN, WAN or Dial-Up Networking, this
information is required:
information is required:
•
FTP Username: PlotWorks
•
FTP Password: smith
•
Host’s IP Address: 131.107.2.2 (or computer name, if an LMHOSTS file
has been configured
has been configured
therefore you would enter in the Destination path:
PlotWorks:smith@131.107.2.2
Example: If the destination is using a proxy, the destination path will contain:
•
Remote-Username: PlotWorks
•
Host-Site: Xerox
•
Remote-Password: smith
•
Proxy Name or IP address (a name is usually used): printserver
Therefore, you would enter in the Destination path:
PlotWorks@Xerox:smith@printserver (see Fig 4.49).
6.
Select the box that says Use dial-up networking to connect to destination.
If RAS is not installed, this field is disabled. RAS/Dial-up Networking must be in-
stalled (from your Windows NT, 95, or 98 CD) and configured in the Windows op-
erating system for both the client (for sending) and the server, or hub (for
receiving). Refer to Appendix G:“Configuring RAS to Output PlotWorks Job
Files,” for more information.
stalled (from your Windows NT, 95, or 98 CD) and configured in the Windows op-
erating system for both the client (for sending) and the server, or hub (for
receiving). Refer to Appendix G:“Configuring RAS to Output PlotWorks Job
Files,” for more information.
7.
Select the destination phonebook entry, and enter your account name and
password in the appropriate fields.
password in the appropriate fields.
8.
Select Send additional information from Template.INF file if needed
(Template.INF is required if selecting this option).
(Template.INF is required if selecting this option).
9.
The Prompt for User Information on submission check box is checked by
default. User Information is automatically included in the .INF file. When this
box is selected, the User Information dialog box is generated when the file is
submitted for printing. This allows you to make any final changes to the User
Information before submission.
default. User Information is automatically included in the .INF file. When this
box is selected, the User Information dialog box is generated when the file is
submitted for printing. This allows you to make any final changes to the User
Information before submission.
10. Click OK to save the configuration and close the dialog box.
When you are ready to send a job using FTP, click Output Job and select the FTP
site as the destination (if it is not already selected). See “Output to FTP” on page
4-72 for more information.
site as the destination (if it is not already selected). See “Output to FTP” on page
4-72 for more information.