Xerox Document Workstation with PlotWorks Support & Software ユーザーガイド
PlotWorks User Guide • The Job Editor • 4-121
To send a TEMPLATE.INF file:
1.
Open the Setup menu and select Configure Destinations. The following
dialog box displays.
dialog box displays.
Fig 4.76
Configure
Destin-
ation dia-
log box
2.
Click Add to display the Add Destination dialog box (see Fig 4.38).
3.
Select Send additional information from Template.INF.
4.
Click OK.
5.
When you select Output to send your print job to a disk, network or modem,
the TEMPLATE.INF file displays as the Special Instruction dialog box,
shown below:
the TEMPLATE.INF file displays as the Special Instruction dialog box,
shown below:
Fig 4.77
Special
Instruction
dialog box
The questions are listed on
the top half of the window.
the top half of the window.
Type your responses in the
bottom half.
bottom half.
6.
Click Next to proceed through the questions, or Back to return to the previous
question. If the TEMPLATE.INF file requires you to answer a particular
question, you cannot select Next or OK until you have entered a response.
question. If the TEMPLATE.INF file requires you to answer a particular
question, you cannot select Next or OK until you have entered a response.
7.
When you have answered the last question, click OK. The job information
file will be created and submitted with the job.
file will be created and submitted with the job.