Xerox 4215 MICR MRP 管理者ガイド
<
cut top 2"
cut 1">
DIIIIIIIIHHHHHHHHIIIIIIIIIIIII
Operator Guide
3-5
Print Language
The default print language is determined by the
placement of a shunt over a 3-pin jumper (ST2).
The illustration below shows the jumper
configuration. The printer works properly only
with the jumper in the standard configuration.
The shunt should always be placed over the two
pins closest to the edge of the interface card.
placement of a shunt over a 3-pin jumper (ST2).
The illustration below shows the jumper
configuration. The printer works properly only
with the jumper in the standard configuration.
The shunt should always be placed over the two
pins closest to the edge of the interface card.
DO NOT move the jumper shunt. The jumper
ST2
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
a a a a a a a a a a a a
Printer Language (twinax only)
Figure 3-5 shows the printer language switch
settings. The default language setting is
configured by your Xerox service representative
settings. The default language setting is
configured by your Xerox service representative
XEROX 4219/MRP Mid Range Systems Printer
XEROX 4215/MRP Mid Range Systems Printer