Xerox DocuTech 6100 Production Publisher ユーザーガイド

 
DT6180 HandyBook                                                                                                                   103 

NOTE: You can select [Close] to close the Printer Fault window without clearing the fault. However, 
the fault will remain until it is reset through the Printer Fault Clearance window.  

5.  Select [Redisplay] on the Printer Faults window to update and redisplay the Printer Fault list. The 

Printer Fault list will update, and any additional faults will then be displayed. If there are other faults 
on the list, repeat step 4 to clear the faults.  

6.  Select [Close] when you have completed your work in the Printer Faults Clearance window. 

 

 
NOTE: Even if paper is not visible, go through the sequence to clear the paper jam. Carefully inspect the 
rollers for any debris or torn pieces of paper. When clearing misfeeds, make sure a full sheet of paper is 
cleared and there are no pieces of paper left in the machine. 
 
To clear area 4:  

1.  Open the right Processor Door using the handle above Paper Tray 1.  
2.  Grasp the green handle located in the lower left corner of the machine; approximately three inches 

from the bottom. 
 

 

3.  Pull the handle out toward you, and up at the same time.  
4.  Remove all paper in the area below Paper Tray 2.  
5.  Pull the handle toward you, then release and lower the handle into position.  
6.  Close the Processor Door. 

 

 
To clear areas 11 and 14:  

1.  Open the Finisher Doors using the handle above Paper Tray 3.