Xerox DocuTech 6100 Production Publisher ユーザーガイド

 
DT6180 HandyBook                                                                                                                   82 

 
NOTE: The Q1202 and Q1203 Sensors are in area 12.  

1.  Fold a sheet of 216 mm x 279 mm (8.5 x 11 inch) or A4 (210 mm x 297 mm / 8.3 x 11.7 inch) paper 

twice to make a 51 mm (2 inch) wide strip. This will be used to clear the sensor.  

2.  Open the Finisher Doors. The handle for these doors is located above Paper Tray 3.  

 

 

 

 

3.  Open the Finisher Top Cover. 

 

 

4.  When you open the Finisher Top Cover you will see a mechanical assembly on the left side of the 

machine. The assembly has two sensors toward the front of the machine.  
 
The sensors are shiny, black plastic rectangles, 6 mm (¼ inch) wide and 51 mm (2 inches) from 
front to back and have a red, an orange, and a purple wire leading to them with small white 
lettering. The Q1203 sensor is on the top front area of the assembly, and the Q1202 sensor is on 
the left side of the assembly, about 254 mm (10 inches) from the top.  
 

 

5.  Pull on the green handle to open the access plate between the two sensors. Opening the access 

plate allows easier access to both sensors.