Xerox FreeFlow Makeready Support & Software インストールガイド

Xerox

FreeFlow

Makeready

Remote Scan Integration

702P03789

© 2015 Xerox Corporation. All rights reserved. Xerox® and Xerox and Design® are trademarks of Xerox Corporation in the United States
and/or other countries BR#14281

Description

FreeFlow

Makeready now supports remote scanning with two options. Both options are available under the

Makeready Insert > Remote Scan menu option.

• Windows Image Acquisition (WIA) with support for Automatic document feeder scanners
• Scan from the Device with Xerox-enabled Extensible Interface Platform (EIP) version 2.5 and above

multifunction printers (MFPs)

Refer to the Xerox

FreeFlow

Makeready Customer Expectations Document for the list of Xerox printers that

support Remote Scan Integration with Makeready. This document may be obtained from your Xerox Sales
Representative or downloaded from the Support & Drivers section on

http://www.Xerox.com

Using Windows Image Acquisition Scanning

Prerequisites

Check that the following are enabled before you use Windows Image Acquisition (WIA) scanning:

1. The printer must be connected directly to your network and have a proper IP address. To check the IP

address that should be used, at the machine console attached to the printer press the Machine Status
button and note the IPV4 address that is listed.

2. The printer must support WSD and must have that option enabled. The option can be enabled using one

of the following:

A. At the physical printer:

i. Using the machine console attached to the printer, press the Login / Logout button. Login as

the System Administrator.

ii. Press the Machine Status button.

iii. Navigate to Tool > Network and Connectivity setting > Port setting > WSD. The WSD

option should be set to Enabled.

iv. If the WSD setting is not enabled, select [Change Setting], select WSD Scan-Port Status

and then select [Change Setting] again.

v. Select Enabled and then [Save].

vi. Press the Login / Logout button and logout.

vii. When prompted, press [Reboot Now].

B. Remotely:

i. Connect to the CentreWare Internet Services on the printer by launching a Web Browser from

any desktop using the URL

http://<Print

er IP address>

ii. Select the Properties tab.

iii. Login with the Admin account and Password.

iv. From the left panel, select Connectivity > Port Settings . Set WSD Scan to Enabled.

v. Click [Apply].

vi. When requested, select [Reboot Machine] to restart the printer.