Craftsman SM1852RC ユーザーズマニュアル

42

43

●  To avoid fire or toxic reaction, 

●  To avoid injury from unexpected 

●  To avoid electrical shock, fire or 

The carbon brushes furnished will last

approximately 50 hours of running 

time, or 10,000 ON/OFF cycles. 

Replace both carbon brushes when 

either has less than 1/4 in. length of 

carbon remaining, or if the spring or 

wire is damaged or burned. To inspect 

or replace brushes, first unplug the 

saw. Then remove the black plastic 

cap (1) on the side of the motor (2). 

Remove the cap cautiously, because 

it is springloaded. Then pull out the 

brush (3) and replace. Replace for the 

other side. To reassemble reverse the 

procedure. The ears on the metal end 

of the assembly go in the same hole 

the carbon part fits into. Tighten the 

cap snugly, but do not overtighten.

NOTE: To reinstall the same brushes, 

first make sure the brushes go back in 

the way they came out. This will avoid 

a break-in period that reduces motor 

performance and increases wear.

Do not use the saw without the lower 

blade guard. The lower blade guard is 

attached to the saw for your protection. 

Should the lower guard become 

damaged, do not use the saw until the 

damaged guard has been replaced. 

Develop a regular check to make sure 

the lower guard is working properly. 

Clean the lower guard of any dust or 

buildup with a damp cloth.

1

2

3