Zanussi ZBF22451SA ユーザーズマニュアル

Do a final check to make sure that:

• All screws are tightened.

• The magnetic seal adheres to the

cabinet.

• The door opens and closes

correctly.

If the ambient temperature is cold

(i.e. in Winter), the gasket may not fit

perfectly to the cabinet. In that case,

wait for the natural fitting of the

gasket.

In case you do not want to carry out

the above mentioned operations,

contact the nearest Authorised

Service Centre. The Authorised

Service specialist will carry out the

reversibility of the doors at your cost.

Make sure that the mains cable can move freely.
1. If necessary cut the adhesive sealing strip

and then apply it to the appliance as shown

in figure.

2. Drill the unit using a Ø 2.5 mm drill (10 mm

max. penetration), Fix the square fitting to

the appliance.

x

x

 

13mm

Ø 2,5

3. Push the appliance in the direction of the

arrows (1) until the upper gap cover stops

against the kitchen furniture.

4. Push the appliance in the direction of the

arrows (2) against the cupboard on the

opposite side of the hinge.

5. Make sure that the distance between the

appliance and the cupboard front-edge is

44 mm.

6. The lower hinge cover (in the accessories

bag) makes sure that the distance between

the appliance and the kitchen furniture is

correct.

7. Make sure that the clearance between the

appliance and the cupboard is 4 mm.

8. Open the door. Put the lower hinge cover in

position.

 

4mm

44mm

9. Attach the appliance to the niche with 4

screws.

10. Remove the correct part from the hinge

cover (E). Make sure to remove the part DX,

in the case of right hinge, SX in opposite

case.

 

11. Attach the covers (C, D) to the lugs and the

hinge holes.

12. Install the vent grille (B), attach the hinge

covers (E) to the hinge.

13. Disconnect the parts (Ha), (Hb), (Hc) and

(Hd).

 

14. Install the part (Ha) on the inner side of the

kitchen furniture.

15. Push the part (Hc) on the part (Ha).