Zanussi ZDT21003FA ユーザーズマニュアル

You cannot activate the appliance.

• Make sure that the mains plug is connected to the

mains socket.

• Make sure that there is no damaged fuse in the fuse

box.

The programme does not start.

• Make sure that the appliance door is closed.

• The appliance has started the procedure to re-

charge the resin inside the water softener. The dura-

tion of the procedure is approximately 5 minutes.

The appliance does not fill with water.

• The end indicator flashes 1 time inter-

mittently.

• Acoustic signal sounds 1 time intermit-

tently.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is

not too low. For this information, contact your local

water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter in the inlet hose is not clog-

ged.

• Make sure that the inlet hose has no kinks or bends.

The appliance does not drain the water.

• The end indicator flashes 2 times inter-

mittently.

• Acoustic signal sounds 2 times inter-

mittently.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or

bends.

The anti-flood device is on.

• The end indicator flashes 3 times inter-

mittently.

• Acoustic signal sounds 3 times inter-

mittently.

• Close the water tap and contact an Authorised

Service Centre.

The appliance stops and starts more

times during operation.

• It is normal. It provides optimal cleaning results and

energy savings.

Small leak from the appliance door.

• The appliance is not level. Loosen or tighten the ad-

justable feet (if applicable).

• The appliance door is not centred on the tub. Adjust

the rear foot (if applicable).

The appliance door is difficult to close.

• The appliance is not level. Loosen or tighten the ad-

justable feet (if applicable).

• Parts of the tableware are protruding from the bas-

kets.

Rattling/knocking sounds from inside the

appliance.

• The tableware is not properly arranged in the bas-

kets. Refer to basket loading leaflet.

• Make sure that the spray arms can rotate freely.

The appliance trips the circuit-beaker.

• The amperage is insufficient to supply simultaneous-

ly all the appliances in use. Check the socket am-

perage and the capacity of the meter or turn off one

of the appliances in use.

• Internal electrical fault of the appliance. Contact an

Authorised Service Centre.