Zanussi ZWF01483W ユーザーズマニュアル

2. Adjust the flap in posi-

tion B.

3. Put back the drawer in

the recess.

When you use the liquid detergent:

• Do not use gelatinous or thick liq-

uid detergents.

• Do not put more liquid then 120

ml.

• Do not set the delay start.

When the flap is in posi-

tion B and you want to

use powder detergent:

1. Remove the drawer.

2. Adjust the flap in po-

sition A.

3. Put back the drawer

in the recess.

• Measure out the detergent and the fabric condi-

tioner.

• Put the detergent and the fabric conditioner into

the compartments.

• Carefully close the detergent drawer.

ACTIVATING THE APPLIANCE
Press and hold for a couple of seconds the On/Off

button to activate or deactivate the appliance.
A tune sounds when the appliance is activated.

The display shows the word On.

1. Touch the programme button   and set the

programme:

• The indicator of the button 

 flashes.

• The display shows the programme duration.

2. If necessary, change the temperature and the

spin speed or add available options. When you

activate an option, the indicator of the set

option comes on.

If you set something incorrect, the
display shows the message 

.

Touch the button 

 .

• The indicator of the button 

 stops to

flash and stays on.

• The programme starts, the door locks, the

indicator 

 is on.

• The drain pump can operate for a short time

at the beginning of the washing cycle.

After approximately 15 minutes from

the start of the programme:

• The appliance adjusts automatically

the programme duration agree with

the laundry load.

• The display shows the new value.

1. Touch the button 

 again and again to

choose the number of hours in which you want

the washing cycle to be finished.

The display shows the number of hours you set
(e.g. 

) and the indicator above the button 

 is

on to show that his option is active.
2. Touch the button 

 :

• The door is locked.

• The appliance starts the countdown.

• When the countdown is completed, the

programme starts automatically.

You can cancel or change the set of

the Finish In option before you touch
the button 

 . After touching the

button 

 you can only cancel the

Finish In option.

To cancel the the Finish In option:

a. Touch the button 

 to set the appliance

to pause. The indicator of button 

flashes.

b. Touch the button 

 until the indicator

above this button goes off.
Touch the button 

 again to start the

programme immediately.

CHANGING THE OPTIONS
You can change only some options before they

operate.