Zanussi ZWD81683NW ユーザーズマニュアル

FROST PRECAUTIONS
If the appliance is installed in an area where the

temperature can be less than 0° C, remove the

remaining water from the inlet hose and the drain

pump.
1. Disconnect the mains plug from the mains

socket.

2. Close the water tap.

3. Put the two ends of the inlet hose in a

container and let the water flow out of the

hose.

4. Empty the drain pump. Refer to the emergency

drain procedure.

5. When the drain pump is empty, install the inlet

hose again.

WARNING! Make sure that the

temperature is higher than 0 °C before

you use the appliance again.

The manufacturer is not responsible

for damages caused by low

temperatures.

WARNING! Refer to Safety chapters.

INTRODUCTION
The appliance does not start or it stops during

operation.
First try to find a solution to the problem (refer to

the table). If the problem persists, contact the

Authorised Service Centre.
With some problems, the acoustic signals

code:
•

 - The appliance does not fill with water

properly.

•

 - The appliance does not drain the water.

•

 - The appliance door is open or not

closed correctly. Please check the door!

If the appliance is overloaded,

remove some items from the drum

and/or keep pressed the door and

push the Start/Pause button at the
same time until the indicator 

stops flashing (see the picture

below).

•

 - The mains supply is unstable. Wait until

the mains supply is stable.

•

 - No communication between electronic

elements of the appliance. Switch off and

switch on again.

WARNING! Deactivate the appliance

before you do the checks.

The programme does not

start.

Make sure that the mains plug is connected to the mains socket.

 

Make sure that the appliance door is closed.