Kraft KF-SM 60102 MWL ユーザーズマニュアル

P.21

P.20

   Clean detergent box and grooves

Clean detergent drawer and grooves

1.Press down the arrow location on softener cover 

   inside the drawer.

2.Lift the clip up and take out softener cover and wash 

   all grooves with water.

3.Restore the softener cover and push the drawer into 

   position.
    

Inlet filter shall must be cleaned if there is not any or 

insufficient water in when the tap is opened.

Clean the tap filter:

1.Close the tap.

2.Select any procedure except “Wash” or “Drain” 

   procedure.

3.Press the button “Start/Pause” and keep the

   procedure running for about 40 seconds.

4.Remove the inlet pipe from the tap.

5.Use water to wash the filter.

6.Reconnect the inlet pipe.

Washing the filter in washing machine:

1.Screw off the inlet pipe from the backside of the 

   machine.

2.Pull out the filter with long nose pliers and reinstall 

   it back after being washed.

3.Reconnect the inlet pipe.

4.Open the tap and make sure there is no water leakage.

5.Close the tap.

Notes: Generally, the tap filter is washed first and then the filter in washing machine will be washed. 

If only the filter in washing machine is washed, then the steps 1~3 in cleaning the tap filter shall be 

repeated.

Before your maintenance starts, please do pull out the power plug or disconnect power 

and close the tap.

       

-  Solvents are forbidden to avoid that the washing machine is damaged, and toxic gases 

   are generated or exploded.

-  Never use water to sprinkle and wash the washing machine.

-  It is forbidden that the detergents containing PCMX are used to clean the washing machine.
      

Proper maintenance on the washing machine can extend its working life. The surface can 

be cleaned with diluted non-abrasive neutral detergents when necessary. If there is any 

water overflow, use the wet cloth to wipe it off immediately. No sharp items are allowed to 

strike the cabinet.

Notes: formic acid and its diluted solvents or equivalent are forbidden.

      

The rusts left inside the drum by the metal articles shall be removed immediately with 

chlorine-free detergents.

Never use steel wool.
      

When the temperature drops below zero and your washing machine gets frozen, you may:

1.Disconnect the power supply for the washing machine.

2.Wash the tap with warm water to loosen inlet pipe.

3.Take down inlet pipe and immerse it in warm water.

4.Pour warm water into washing drum and wait for 10 minutes.

5.Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.

Notes: when the washing machine is reused, make sure the ambient temperature is above 0 C

      

If your washing machine is located in the room where it can get frozen easily, please drain 

the remaining water inside drain pipe and inlet pipe thoroughly.  

Remove the remaining water in inlet pipe:

1.Close the tap.

2.Screw off the inlet pipe from tap and put its end into the container.

3.Start up any procedure except single Wash or Drain 

   procedure. Water will be drained out of inlet pipe if any 

   for about 40 seconds.

4.Reconnect the inlet pipe to tap.

        

T

o avoid burning, it shall be done after the hot water 

inside the machine cools down.