Cisco Cisco IOS Software Release 12.2(58)SE
20
Release Notes for the Cisco Catalyst Blade Switch 3130 and 3032 for Dell, Cisco IOS Release 12.2(58)SE1
OL-24332-01
Open Caveats
Open Caveats
•
CSCtg98453
When you make port security changes on an interface, such as configuring aging time, violations,
or aging type, error messages and tracebacks might appear.
or aging type, error messages and tracebacks might appear.
There is no workaround.
•
CSCtl32991
Unicast EIGRP packets destined for the switch are sent to the host queue instead of to the higher
priority routing protocol queue.
priority routing protocol queue.
Note
This does not occur when packets are routed through the switch to another destination.
There is no workaround.
•
CSCtl60247
When a switch or switch stack running Multiple Spanning Tree (MST) is connected to a switch
running Rapid Spanning Tree Protocol (RSTP), the MST switch acts as the root bridge and runs
per-VLAN spanning tree (PVST) simulation mode on boundary ports connected to the RST switch.
If the allowed VLAN on all trunk ports connecting these switches is changed to a VLAN other than
VLAN 1 and the root port of the RSTP switch is shut down and then enabled, the boundary ports
connected to the root port move immediately to the forward state without going through the PVST+
slow transition.
running Rapid Spanning Tree Protocol (RSTP), the MST switch acts as the root bridge and runs
per-VLAN spanning tree (PVST) simulation mode on boundary ports connected to the RST switch.
If the allowed VLAN on all trunk ports connecting these switches is changed to a VLAN other than
VLAN 1 and the root port of the RSTP switch is shut down and then enabled, the boundary ports
connected to the root port move immediately to the forward state without going through the PVST+
slow transition.
There is no workaround.
•
CSCtl81217
When a switch is using a DHCP server to assign IP addresses and an interface on the switch has RIP
enabled, if the switch reloads, the interface loses some RIP configuration (specifically RIP
authentication mode and RIP authentication key-chain). This does not happen when the IP address
is statically configured on the interface. The problem occurs only when you configure RIP before
an IP address is assigned by the DHCP server.
enabled, if the switch reloads, the interface loses some RIP configuration (specifically RIP
authentication mode and RIP authentication key-chain). This does not happen when the IP address
is statically configured on the interface. The problem occurs only when you configure RIP before
an IP address is assigned by the DHCP server.
There is no workaround, but you can use an embedded event manager (EEM) script to add the
interface configuration commands on the interface:
interface configuration commands on the interface:
ip rip authentication mode
ip rip key-chain
•
CSCtq01926
When you configure a port to be in a dynamic VLAN by entering the switchport access vlan
dynamic interface configuration command on it, the switch might reload when it processes ARP
requests on the port.
dynamic interface configuration command on it, the switch might reload when it processes ARP
requests on the port.
The workaround is to configure static VLANs for these ports.
Resolved Caveats
•
CSCsz18045
When you enter the show inventory command on a switch that has an X2 module, the output
incorrectly reports the X2 module version ID (VID) as V01 even though the label has a higher VID.
incorrectly reports the X2 module version ID (VID) as V01 even though the label has a higher VID.