Cisco Cisco Content Security Management Appliance M160 ユーザーガイド

If you enabled AutoSupport during system setup, the email address that you specified will receive alerts 
for all severities and classes by default. You can change the configuration at any time.

Select Management Appliance > System Administration > Alerts. 

Click Add Recipient. 

Enter the recipient’s email address. You can enter multiple addresses, separated by commas.

Select the alert severities that the alert recipient will receive.

Click Submit to add the alert recipient.

Commit your changes.

Alert settings apply to all alerts that the Security Management appliance sends. 

Click Edit Settings on the Alerts page. 

Enter a Header From: address to use when sending alerts, or select “Automatically generated” 
(“alert@<hostname>”).

Select the check box if you want to specify the number of seconds to wait between sending duplicate 
alerts. For more information, see 

.

Specify the initial number of seconds to wait before sending a duplicate alert.

Specify the maximum number of seconds to wait before sending a duplicate alert.

Optionally, enable AutoSupport by selecting the Cisco IronPort AutoSupport option. For more 
information about AutoSupport, see 

If AutoSupport is enabled, the weekly AutoSupport report is sent to alert recipients set to receive system 
alerts at the Information level. You can disable this via the check box.

Submit and commit your changes.

To configure the maximum number of alerts to view in the Top Alerts list, or to disable the Top Alerts 
feature, see