Cisco Cisco ONS 15454 SONET Multiservice Provisioning Platform (MSPP) インストールガイド

Step 1

Log into the node.

Step 2

Ensure that slots 7, 8, 10, and 11 have cards installed. Release 3.0 does not support simplex operation.

Step 3

Repeat Steps 1 and 2 at every node in the network.

Make sure all active telnet sessions to any node in the network are closed.

If any of your nodes have an AIP board with the part number 67-11-00015, the board must be replaced. 
Perform the following steps to ensure that all of your AIP boards are good.

Step 1

Look at the back of your ONS 15454 node and locate the green board with “AIP” stamped into the right 
hand side (the writing will be sideways as you face the board). 

Step 2

Locate the sticker with the part number. The number should be preceded by “P/N” on the sticker. 

Note

If there is no sticker with a part number, the number may be stamped into the board itself. If you 
cannot find the part number, you will need to contact the Technical Assistance Center (TAC) at 
877 323-7368 for assistance.

Step 3

If the part number is any number other than 67-11-00015, go to the next node and start from Step 1 again.

Step 4

If the part number is 67-11-00015, contact the TAC at 877 323-7368 to request a Return Materials 
Authorization (RMA).

Step 5

Repeat Steps 1 – 4 for every node.

Before upgrading from Release 3.0 to Release 3.0.1 software, you must back up the current database for 
all nodes in the network. 

Step 1

Log into CTC.

Step 2

From the node view, click the Maintenance > Database tabs.

Step 3

Click Backup.

Step 4

Save the database on the workstation's hard drive or on network storage. Use an appropriate file name 
with the file extension .db (for example, myDatabase.db).

Step 5

Click Save. A message appears indicating that the backup is complete.

Step 6

Click OK.

Step 7

Repeat Steps 1 – 6 for each node in the network.