Cisco Cisco Catalyst 6500 Series Firewall Services Module トラブルシューティングガイド
Firewall Services Module Connectivity Issues Due
to Switch ARP Policing
to Switch ARP Policing
Document ID: 116330
Contributed by Jay Johnston and Magnus Mortensen, Cisco TAC
Engineers.
Jul 12, 2013
Engineers.
Jul 12, 2013
Contents
Introduction
Prerequisites
Requirements
Components Used
Problem
Solution
Related Information
Prerequisites
Requirements
Components Used
Problem
Solution
Related Information
Introduction
This document describes a specific connectivity problem encountered when you use the Firewall Services
Module (FWSM) in a Cisco 6500 or 7600 Series switch.
Module (FWSM) in a Cisco 6500 or 7600 Series switch.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these hardware and software versions:
Cisco 6500 Series Switch
•
Cisco 7600 Series Router Platforms
•
FWSM
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Problem
For this specific issue, any of these symptoms might be observed:
Network connectivity to or through the FWSM might fail intermittently.
•
Network connectivity through the switch (not through the FWSM) might fail intermittently.
•