Cisco Cisco ONS 15305 Multiservice Customer Access Platform データシート
Data Sheet
© 2008 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Page 3 of 7
Applications
The Cisco ONS 15305 8-Port 10/100 Ethernet Module can be installed in any Cisco ONS 15305
MSPP slot as part of the Cisco multiservice-over-SDH solution. The Cisco ONS 15305 can be
used as customer premises equipment (CPE) for medium-sized and large businesses to transport
traffic over an STM-1, STM-4, or STM-16 SDH uplink to the central office. In this use, the module
collects voice and data traffic from each site for switched voiced and data services, Layer 1 and
Layer 2 VPNs, and Internet access. The module gives the Cisco ONS 15305 the possibility
transporting Ethernet or Fast Ethernet traffic over the SDH network at up to the full line rates of the
LAN-10 or 100 Mbps. Using standard virtual concatenation, SDH bandwidth may also be efficiently
allocated at below line-rate speeds to meet each customer’s needs.
Figure 4. The Cisco ONS 15305 with the 8-Port 10/100 Ethernet Module as CPE to provide Ethernet or
Fast Ethernet over SDH Services
The Cisco ONS 15305 can also be deployed as a central office aggregator, consolidating traffic
from other Cisco ONS 15305 CPE, as well as directly connected customer TDM or data traffic from
electrical interfaces. The Cisco ONS 15305 8-Port 10/100 Ethernet Module can collect Ethernet
traffic from up to 14 SDH virtual containers, and hand off the aggregated packets to the Cisco ONS
15305 2-Port Gigabit Ethernet Module to which it is connected through the centralized Ethernet
crossbar. Traffic from different locations can be logically separated using IEEE 802.1Q-compliant
VLANs. The 2-Port Gigabit Ethernet module can then hand off a Gigabit Ethernet stream, or VLAN
trunk, to a colocated switch or router, to a Cisco ONS 15454 ML-Series, for increased packet-
intelligent transport over the core network. Figure 5 shows a diagram of this application.