Cisco Cisco Content Switching Module トラブルシューティングガイド
Content Switching Module URL Case Sensitivity
Document ID: 26709
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Configuration
Related Information
Prerequisites
Requirements
Components Used
Conventions
Configuration
Related Information
Introduction
This document describes how to configure the Content Switching Module (CSM) for case sensitivity with
URLs. The document configuration defines the URLs.
URLs. The document configuration defines the URLs.
Prerequisites
Requirements
The examples in this document assume that there exist, at minimum:
A basic CSM configuration
•
At least one slb−policy configuration under the vserver configuration
The configuration must reference policy maps in this way:
•
vserver vserver_name
virtual ip_address tcp www
persistent rebalance
slb−policy policy_name
inservice
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Configuration
By default, URLs that are defined in the CSM are case sensitive.