Cisco Cisco UCS B440 M1 High-Performance Blade Server トラブルシューティングガイド
Nexus 1000v and UCS QoS
Configuration/Integration Example
Configuration/Integration Example
Document ID: 117541
Contributed by Vishal Mehta and Manuel Velasco, Cisco TAC
Engineers.
Feb 27, 2014
Engineers.
Feb 27, 2014
Contents
Introduction
Prerequisites
Requirements
Components Used
Configure
Network Setup
Configurations
Verify
Troubleshoot
Prerequisites
Requirements
Components Used
Configure
Network Setup
Configurations
Verify
Troubleshoot
Introduction
This document describes how to configure and troubleshoot Quality of Service (QoS) for Virtual Machines
(VM) on setup of the Cisco Unified Computing System (UCS) and the Cisco Nexus 1000v switch. QoS can
be controlled at the Nexus 1000v and/or at the UCS level. This document demonstrates both variations and
their resulting effects.
(VM) on setup of the Cisco Unified Computing System (UCS) and the Cisco Nexus 1000v switch. QoS can
be controlled at the Nexus 1000v and/or at the UCS level. This document demonstrates both variations and
their resulting effects.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
QoS
•
Cisco UCS
•
VMware ESXi
•
Cisco Nexus 1000V Switch
•
Components Used
The command outputs in this document are based on these software and hardware versions:
Cisco Nexus 5020 Switch Version 5.0(3)N2(2a)
•
Cisco UCS Version 2.1(1d)
•
Cisco UCS B200 M3 Blade Server with Cisco Virtual Interface Card (VIC) 1240
•
vSphere Version 5.1 (ESXi and vCenter)
•
Cisco Nexus 1000V Switch Version 4.2(1)SV2(1.1a)
•
The software version is not a limitation for the demonstrated QoS feature. However, the examples in this