Cisco Cisco Expressway メンテナンスマニュアル
Event
Description
Level
Hardware
Failure
Failure
There is an issue with the Expressway hardware. If the problem persists, contact your
Cisco support representative.
Cisco support representative.
1
License Limit
Reached
Reached
Licensing limits for a given feature have been reached. The Detail event parameter
specifies the facility/limits concerned.
specifies the facility/limits concerned.
If this occurs frequently, you may want to contact your Cisco representative to purchase
more licenses.
more licenses.
1
Message
Received
Received
An incoming RAS message has been received.
2
Message
Received
Received
An incoming RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
been received.
been received.
3
Message
Received
Received
(SIP) An incoming message has been received.
4
Message
Rejected
Rejected
This could be for one of two reasons:
■
If authentication is enabled and an endpoint has unsuccessfully attempted to send
a message to the Expressway. This could be either because the endpoint has not
supplied any authentication credentials, or because its credentials do not match
those expected by the Expressway.
a message to the Expressway. This could be either because the endpoint has not
supplied any authentication credentials, or because its credentials do not match
those expected by the Expressway.
■
Clustering is enabled but bandwidth across the cluster has not been configured
identically, and the Expressway has received a message relating to an unknown
peer, link, pipe, subzone or zone.
identically, and the Expressway has received a message relating to an unknown
peer, link, pipe, subzone or zone.
1
Message Sent
An outgoing RAS message has been sent.
2
Message Sent
An outgoing RAS NSM Keepalive, H.225, H.245 or a RAS message between peers has
been sent.
been sent.
3
Message Sent
(SIP) An outgoing message has been sent.
4
Operator Call
Disconnect
Disconnect
An administrator has disconnected a call.
1
Outbound TLS
Negotiation
Error
Negotiation
Error
The Expressway is unable to communicate with another system over TLS. The event
parameters provide more information.
parameters provide more information.
1
Package Install
A package, for example a language pack, has been installed or removed.
2
Policy Change
A policy file has been updated.
1
POST request
failed
failed
A HTTP POST request was submitted from an unauthorized session.
1
Provisioning
Diagnostic messages from the provisioning server. The Detail event parameter provides
additional information.
additional information.
1
Reboot
Requested
Requested
A system reboot has been requested. The Reason event parameter provides specific
information.
information.
1
Registration
Refresh
Rejected
Refresh
Rejected
A request to refresh a registration has been rejected.
1
239
Cisco Expressway Administrator Guide