Cisco Cisco Unified MeetingPlace Audio Server インストールガイド
Cisco MeetingServer 5.1 Installation Planning Guide
194
Cisco Systems
March 2003
D
Siemens HiPath 4000
Configuration
Configuration
Introduction
When configuring MeetingPlace M3 against a Siemens HiPath 4000 PBX
system, some differences from the standard PBX configuration are
necessary. (For details about this configuration, see the next section,
“Latitude Setup for Siemens HiPath 4000.”)
system, some differences from the standard PBX configuration are
necessary. (For details about this configuration, see the next section,
“Latitude Setup for Siemens HiPath 4000.”)
In particular, you must do the following when programming T1 trunks:
•
Program T1 trunks as TIE type trunks.
•
Program T1 trunks as EMI/Wink (not wink/immediate).
If these changes are not made, the following problems occur:
•
There is no DTMF to MeetingPlace.
•
There is no DTMF from MeetingPlace.
To confirm that DTMF exists both to and from MeetingPlace, test the outdial
by using the “activity” command.
by using the “activity” command.
Cisco Setup for Siemens HiPath 4000
The following pages show a printout of a Siemens HiPath 4000
configuration.
configuration.