Cisco Cisco Unified MeetingPlace Audio Server メンテナンスマニュアル
5-33
Cisco MeetingPlace Audio Server 5.2 Customer Engineering Guide (for Cisco MeetingPlace 8112)
OL-
Chapter 5 Repairing and Maintaining the 8112 Server
Replacing the modem
Step 3
Gently insert the Multi Access Blade card horizontally into the server’s slot. As the card is inserted, the
black plastic handles on the left and right of the card’s front panel must engage with the chassis. When
the card is firmly mounted into the correct position inside the chassis, the red plastic latches within each
handle self-lock.
black plastic handles on the left and right of the card’s front panel must engage with the chassis. When
the card is firmly mounted into the correct position inside the chassis, the red plastic latches within each
handle self-lock.
Step 4
Verify the black handles are in their locked position.
Removing an old Multi Access Blade transition module
Step 1
Verify all steps in the
have been completed.
Step 2
Verify which Multi Access Blade transition module needs replacing. Locate the two red plastic latches
on the top and bottom of the transition module within each black plastic handle.
on the top and bottom of the transition module within each black plastic handle.
Step 3
Press on both red latches and release them.
Step 4
Lift both black plastic handles to unseat the Multi Access Blade transition module.
Step 5
Gently pull the Multi Access Blade transition module out of the chassis.
Installing a new Multi Access Blade transition module
Step 1
Ensure that the system is powered down. If you are installing a new transition module immediately after
removing an old one, the system should still be powered down. Otherwise, follow the steps in the
removing an old one, the system should still be powered down. Otherwise, follow the steps in the
Step 2
Verify which slot number the new Multi Access Blade transition module is going into.
Step 3
Gently insert the Multi Access Blade transition module into the server’s slot. As the transition module
is inserted, the black plastic handles on the top and bottom of the transition module’s panel must engage
with the chassis. When the transition module is firmly mounted into the correct position inside the
chassis, the red plastic latches within each handle self-lock.
is inserted, the black plastic handles on the top and bottom of the transition module’s panel must engage
with the chassis. When the transition module is firmly mounted into the correct position inside the
chassis, the red plastic latches within each handle self-lock.
Step 4
Verify the black handles are in their locked position.
Replacing the modem
This section provides instructions on how to replace the modem.
Note
The modem is external and can be placed in the most safe and convenient place according to the rack
arrangement. The location of the modem should be in a place where the cables are protected and cannot
be pulled out of place.
arrangement. The location of the modem should be in a place where the cables are protected and cannot
be pulled out of place.
For E1 and T1 PRI systems only, the modem sits inside the breakout box.