Cisco Cisco Unified MeetingPlace Audio Server インストールガイド

A MeetingPlace server placed on its own router segment is also immune to 
broadcast storms. A moderately expensive solution is to place a two-Ethernet-
port router between the MeetingPlace system and the main network. An 
example of such a device is the Cisco 2514.

A router-based solution implies creating a new LAN segment with its 

own IP address range.

MeetingPlace Outlook Gateway, MeetingPlace Notes Gateway, MeetingPlace 
E-mail Gateway, MeetingPlace IP Gateway, MeetingPlace Directory Services 
Gateway, MeetingPlace Web, and MeetingPlace Network Backup Gateway 
are other product options available to you. These options run on a dedicated 
Windows NT system or Windows 2000 server that is connected to 
MeetingPlace by TCP/IP over your LAN or WAN.

For descriptions of these gateways, see 

You and your MeetingPlace support representative perform several different 
activities to install MeetingPlace. The following table summarizes these 
activities and indicates who is responsible for each one. A representative from 
Cisco Customer Support installs the hardware, connects it, and helps you with 
the software.

This unit is intended for installation in restricted access areas. A restricted 
access area can be accessed only through the use of a special tool, lock and 
key, or other means of security. Statement 1017

Only trained and qualified personnel should be allowed to install, replace, or 
service this equipment. Statement 1030

To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits 
to telephone-network voltage (TNV) circuits. LAN ports contain SELV circuits, 
and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45 
connectors. Use caution when connecting cables. Statement 1021

The plug-socket combination must be accessible at all times, because it serves 
as the main disconnecting device. Statement 1019