Cisco Cisco Unified MeetingPlace Audio Server メンテナンスマニュアル

Enter your user ID and password. For 

, enter: 

198.207.208.241

.

Using this configuration, you can connect to the MeetingPlace using the 
MeetingTime Client through the modem connection. However, you cannot 
append or retrieve any attachment when connected using this method.

You can also connect a computer directly to the MeetingPlace server with a 
crossover LAN cable. (You can purchase an Ethernet 10 Base-T/100Base-TX 
crossover cable in most electronics stores.)

To construct an Ethernet cable, instead of purchasing one, use the following 
table for wiring information.

If your MeetingPlace server is connected to the LAN, and you want to access 
the MeetingPlace server using the crossover cable while network connectivity 
is down, do the following:

Unplug the Ethernet cable from the back of the MeetingPlace server.

Connect the crossover cable in its place.

Reconnect the LAN cable after the network outage is resolved.

Your computer must be configured to have a static IP address in the same 
subnet as the MeetingPlace Server. For example, if the MeetingPlace server 
has an IP address of 192.168.1.2 with a subnet mask of 255.255.255.0 and a 
default gateway of 192.168.1.1, the IP address for the computer must be 
between 192.168.1.3 and 192.168.1.254, with a subnet mask of 
255.255.255.0.

After the connection is established between the computer and the 
MeetingPlace server, you can use MeetingTime to administer MeetingPlace, 
just as you would over the LAN. Because you may not have access to the 
DNS or WINS server, you may need to use the IP address instead of the 
hostname of the MeetingPlace server in the Address field of MeetingTime.

1

3

2

6

3

1

6

2