Cisco Model D9479 Gigabit QAM Modulator インストールガイド
Chapter 2 Upgrading the Software
24
78-740242-01 Rev B
Example: The following diagram shows an example of a QAM selected in the
QAM List window.
4 Click File and then select Reset. The Question window opens and asks you to
confirm the reset of the QAM.
5 Click Yes. The QAM List window displays the following message:
The reset request has been received by QAM modulator <Name of QAM>
Notes:
Notes:
The <Name of QAM> represents the name of the modulator you just reset.
It may take up to 5 minutes for each modulator to reset.
6 Do you see the IP address for the QAM you reset in the bootpd log file?
If yes, continue with this procedure.
If no, call Cisco Services.
Note: For details about IP addresses in the bootpd log file, go to
Preparing to
Monitor Remote QAM Resets (on page 22).
7 Repeat steps 3 through 6 for up to three additional modulators, and then go to
step 8.
Important! Never reset more than four modulators at once, or you may cause
Important! Never reset more than four modulators at once, or you may cause
QAMs to have to retry downloads due to traffic congestion on the network.
8 Choose one of the following options and then go to step 9 of this procedure.
For QAMs that carry broadcast sessions, go to Verifying the Functionality of
QAM Modulators That Carry Broadcast Sessions (on page 27).
For QAMs that carry xOD or VOD sessions, go to Verifying the Functionality
of QAM Modulators That Carry xOD or VOD Sessions (on page 29).
9 Do you have additional modulators to reset?
If yes, repeat steps 3 through 8.
If no, go to step 10.
10 Click File and select Close to close the QAM List window.