Cisco Cisco Tunnel Terminating Gateway (TTG) 管理者ガイド
System Settings
Verifying and Saving Your Interface and Port Configuration ▀
Cisco ASR 5000 System Administration Guide ▄
49
Verifying and Saving Your Interface and Port Configuration
Verify that your interface configuration settings are correct by entering the following command:
show ip interface
The output from this command should be similar to that shown below. In this example an interface named mgmt2 was
configured in the local context.
configured in the local context.
Intf Name: mgmt2
Intf Type: Broadcast
Description: management2
VRF: None
IP State: UP (Bound to 24/2)
IP Address: 192.168.100.3 Subnet Mask: 255.255.255.0
Bcast Address: 192.168.100.255 MTU: 1500
Resoln Type: ARP ARP timeout: 60 secs
L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Intf Type: Broadcast
Description: management2
VRF: None
IP State: UP (Bound to 24/2)
IP Address: 192.168.100.3 Subnet Mask: 255.255.255.0
Bcast Address: 192.168.100.255 MTU: 1500
Resoln Type: ARP ARP timeout: 60 secs
L3 monitor LC-port switchover: Disabled
Number of Secondary Addresses: 0
Verify that the port configuration settings are correct by entering the following command:
show configuration port slot#/port#
slot#
is the chassis slot number of the line card where the physical port resides. slot# is either 24 or 25.
port#
is the
number of the port (either 1 or 2).
This following command produces an output similar to the one shown below. It displays the configuration of port 2 of
the SPIO installed in chassis slot 24. In this example, the port is bound to an interface called mgmt2.
the SPIO installed in chassis slot 24. In this example, the port is bound to an interface called mgmt2.
config
port ethernet 24/2
description management2
no shutdown
bind interface mgmt2 local
#exit
end
port ethernet 24/2
description management2
no shutdown
bind interface mgmt2 local
#exit
end
Save your configuration as described in Verifying and Saving Your Configuration.