Cisco Cisco C880 M4 Server インストールガイド
5.Hard Disk Drives
25
5.3. Hot-Plug for Hard Disk Drives
CAUTION!
Before replacing an hard disk drive: To ensure the replacing of the correct hard disk drive, switch on
the blinking of the amber Fault LED (
section
) of the
depending hard disk drive by ServerView RAID.
If you want to replace an SAS hard disk drive during operation, proceed as follows:
If you want to pull out a hard disk drive which is not defective, you must
ensure that no reading or writing access to this hard disk drive is possible.
Pull the hard disk drive (defective/not defective) out by a few centimeters.
Wait for at least 60 seconds.
This period is necessary for the Host Bus Adapter to recognize that a hard disk drive has been
pulled out and for the hard disk drive to come to a stop.
Pull the hard disk drive right out.
Insert the new hard disk drive.
When you have removed the hard disk drive and are not fitting any replacement, then fit a blank insert into
the blank bay. Ensure that the blank insert engages in the bay correctly.