Cisco Cisco MGX-FRSM-HS2 B Serial Frame Service Module 技術マニュアル

ページ / 13
Wireless LAN Controller (WLC) Configuration Best
Practices
Document ID: 82463
Contributed by Cisco TAC Engineers.
Mar 27, 2014
Contents
Introduction
Prerequisites
     Requirements
     Components Used
Best Practices
     Wireless/RF
     Network Connectivity
     Network Design
     Mobility
     Security
     General Administration
     How to Transfer the WLC Crash File from the WLC CLI to the TFTP Server
     Upload Core Dump File to an FTP Server
     User Friendliness
Introduction
This document offers short configuration tips that cover several Wireless Unified Infrastructure issues
commonly seen in the Technical Assistance Center (TAC). The objective is to provide important notes that
you can apply on most network implementations in order to minimize possible problems.
Note: Not all networks are equal, therefore some tips might not be applicable on your installation. Always
verify them before you perform any changes on a live network.
Prerequisites
Requirements
Cisco recommends that you have knowledge of these topics:
Knowledge of how to configure the Wireless LAN Controller (WLC) and Lightweight Access Point
(LAP) for basic operation
• 
Basic knowledge of Control And Provisioning of Wireless Access Points (CAPWAP) protocol and
wireless security methods
• 
Components Used
The information in this document is based on these software and hardware versions: