Cisco Cisco Content Switching Module 技術マニュアル
Configuring FTP Server Load Balancing Using IOS
SLB
SLB
Document ID: 12577
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Troubleshooting Commands
Prerequisites
Requirements
Components Used
Conventions
Background Information
Configure
Network Diagram
Configurations
Verify
Troubleshoot
Troubleshooting Commands
% Cannot enable server nat because vserver [chars] has FTP enabled
Dispatched Mode Loopback
Related Information
Dispatched Mode Loopback
Related Information
Introduction
This document provides a sample configuration for FTP server load balancing with the help of Cisco IOS
Server Load Balancing (SLB).
Server Load Balancing (SLB).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on these software and hardware versions:
Catalyst 6000 family Supervisor Cisco IOS® Software Release 12.1(8)E for Supervisor Engine 1 with
MSFC1 (c6sup11−jsv−mz.121−8a.E)
MSFC1 (c6sup11−jsv−mz.121−8a.E)
•
Microsoft Windows 2000/IIS FTP Servers
•
The information in this document was created from the devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.
devices used in this document started with a cleared (default) configuration. If your network is live, make sure
that you understand the potential impact of any command.