Cisco Cisco Unified MeetingPlace for IBM Lotus Notes クイック設定ガイド
Using the Command-Line Interface (CLI) in Cisco Unified MeetingPlace
Command Reference
10
net
Lists the current network configuration settings and allows you to change them after the system has been
installed. Most changes take affect after restarting the system.
installed. Most changes take affect after restarting the system.
Caution
A system restart terminates all existing call connections. Proceed only during a scheduled
maintenance period or during a period of extremely low usage. Note: When you restart the Web
Server, all manual changes made to the registry are lost.
maintenance period or during a period of extremely low usage. Note: When you restart the Web
Server, all manual changes made to the registry are lost.
Use the net command to set the following:
•
Port configuration parameters, including:
–
Application Server (eth0) hostname, IP address, subnet mask, and default gateway
–
Virtual (eth0:0) hostname, IP address, subnet mask, and default gateway—the eth0:0 virtual interface
is used in
is used in
deployments
–
MTU and link parameters (auto-negotiation, speed, duplex).
•
Domain name
•
DNS servers
•
NTP servers
Note
If you change the Application Server hostname (for eth0), then you must also perform the following
actions:
actions:
–
Configure the DNS
1
server to point the old hostname to the new hostname.
–
Restart the application by entering either the
restart operating system command or the
reboot Linux command.
–
If you enabled SSL for the Application Server, then complete the
sections
in the
module.
–
If you installed MeetingPlace Conference Manager, then complete the
section in the
module.
–
If your system includes a Web Server, then complete the
section in the
module.
–
If you integrated the system with Cisco WebEx, then notify the Cisco WebEx administrator to update
the Cisco Unified MeetingPlace hostname that is configured in the Cisco WebEx license manager.
the Cisco Unified MeetingPlace hostname that is configured in the Cisco WebEx license manager.
Syntax: net
ntpdate
Sets the Application Server date and time to match the time obtained by polling an NTP
2
server.
Syntax: ntpdate [-u] ntp-server
Parameters:
•
-u—Specifies to send packets through an unprivileged port to communicate with the NTP server. Use this
option when you want to reach an NTP server that is beyond a firewall.
option when you want to reach an NTP server that is beyond a firewall.
•
ntp-server—Hostname or IP address of the NTP server.
Table 1
Command Reference: Application Commands (continued)
Command
Description