Cisco Acano X-series
Cisco Meeting Server Release 2.0 : Deployments with Call Control Guide
22
B Configuring a Polycom DMA for the Cisco
Meeting Server
Meeting Server
For calls from a Polycom DMA environment to the Cisco Meeting Server, create an External SIP
Peer on the Polycom DMA that will point to the Meeting Server, and then configure a Dial Rule on
the Polycom DMA that will direct calls to it.
Peer on the Polycom DMA that will point to the Meeting Server, and then configure a Dial Rule on
the Polycom DMA that will direct calls to it.
The following is an example of configuring theMeeting Server for the Polycom DMA, and may
need to be adapted. Follow the instructions in the Deployment guides to set up a dial plan rule
that points to the Polycom DMA server in the Web Admin Interface Configuration > Outbound
Calls page. Also ensure that the correct ports are open (Incoming/Outgoing UDP 32768-
65535 – RTP).
need to be adapted. Follow the instructions in the Deployment guides to set up a dial plan rule
that points to the Polycom DMA server in the Web Admin Interface Configuration > Outbound
Calls page. Also ensure that the correct ports are open (Incoming/Outgoing UDP 32768-
65535 – RTP).
Note: If you are not your organization's Polycom server administrator, then Cisco strongly
advises you to seek the advice of your local administrator on the best way to implement the
equivalent on your server’s configuration.
advises you to seek the advice of your local administrator on the best way to implement the
equivalent on your server’s configuration.
B.1 Setting up the External SIP Peer
On the Polycom DMA:
1. Go to Network > External SIP Peer > Add
2. In the External SIP Peer page configure the following:
l
Name: Cisco Systems
l
Description: a meaningful phrase, possibly Cisco Systems IP Peer
l
Next hop Address: IP Address of the Meeting Server Call Bridge
B Configuring a Polycom DMA for the Cisco Meeting Server