Cisco Headend System Release 2.7
Disable the SAM Process on Aptiv Systems
4019475 Rev D
93
Disable the SAM Process on Aptiv Systems
If the site you are upgrading uses the Aptiv application server, you need to disable
the SAM process before you restart the system components. Complete the following
steps to disable the SAM process.
the SAM process before you restart the system components. Complete the following
steps to disable the SAM process.
Notes:
If the site you are upgrading does not use the Aptiv application server, skip this
procedure and go to Restart the System Components (on page 94).
procedure and go to Restart the System Components (on page 94).
You should be logged on to the DNCS as dncs user.
1 In the DNCS section of the DNCS Administrative Console Status window, click
Control. The DNCS Monitor window opens.
2 From an xterm window on the DNCS, type dncsControl and then press Enter.
The DNCS Control window opens.
3 Type 4 (for Define/Update Grouped Elements) and then press Enter. The
window updates to list a series of element groups.
4 Type 14 (for saManager) and then press Enter. The window updates to list the
elements in the group.
5 Type 1 (for /dvs/dncs/bin/saManager) and then press Enter. The first in a
series of confirmation messages appears.
6 Press Enter at each confirmation message to accept the default setting until a
message about cpElmtExecCtrlStatus appears. In total, you should see about six
confirmation messages.
confirmation messages.
7 At the cpElmtExecCtrlStatus message, type 2 (for Disabled) and then press Enter.
A confirmation message appears.
8 Type y (for yes) and then press Enter. The message Element Definition was
Modified appears.
9 Follow the on-screen instructions to exit from the DNCS Control window.