Cisco Cisco D9824 Advanced Multi Decryption Receiver インストールガイド
Setup Menu
78-4039426-01 Rev D
67
Menu Item
Description
Parameters
Reset Credentials
If for some reason, you cannot access
the decoder (due to a forgotten
password, corrupted data, etc.), the
recovery procedure for the decoder is
as follows:
the decoder (due to a forgotten
password, corrupted data, etc.), the
recovery procedure for the decoder is
as follows:
Using the keypad, choose this field on
the front panel menu. A default login
username and randomly generated
password will be displayed on the
front panel display for approximately
30 seconds. The new account will
have Admin privileges. It is
recommended that this account be
replaced by a login
username/password chosen by the
administrator. To change the
username and password, you must be
an Admin user. Refer to Setting
Admin User Privileges via a Telnet
Connection (on page 26).
the front panel menu. A default login
username and randomly generated
password will be displayed on the
front panel display for approximately
30 seconds. The new account will
have Admin privileges. It is
recommended that this account be
replaced by a login
username/password chosen by the
administrator. To change the
username and password, you must be
an Admin user. Refer to Setting
Admin User Privileges via a Telnet
Connection (on page 26).
Note: After this recovery procedure,
all existing user accounts will be lost.
all existing user accounts will be lost.
Password
Complexity
Complexity
Sets the password complexity for all
users. The complexity level changes
will only affect the new user accounts
and password changes. It will not
affect existing accounts.
users. The complexity level changes
will only affect the new user accounts
and password changes. It will not
affect existing accounts.
No Checking, Minimal Checking, or
Full Complexity Checking
Full Complexity Checking
For more information, see the
Password Complexity table below.
Password Complexity table below.
SNTP Server
Sets the NTP server address. If the
NTP server address is not set (0.0.0.0),
the IRD will not attempt to connect to
the server.
NTP server address is not set (0.0.0.0),
the IRD will not attempt to connect to
the server.
12 digits in length (###.###.###.###)
SNTP Enable
Periodically request NTP timestamps
from the NTP server and to
synchronize its system (i.e., non-DVB
related) time with the NTP server.
from the NTP server and to
synchronize its system (i.e., non-DVB
related) time with the NTP server.
Yes or No
Password Complexity
Password Complexity
Description
No Checking
There are no restrictions on passwords.
Note: A minimum of one character is required.