Cisco Cisco Agent Desktop 10.0 インストールガイド
Cisco CAD Installation Guide
66
October 16, 2015
CAD Configuration Setup Utility
The CAD Configuration Setup utility is launched automatically when the CAD base
services installation finishes. Use the CAD Configuration Setup utility to configure the
CAD base services. You can run the utility again later to change your configuration
settings.
services installation finishes. Use the CAD Configuration Setup utility to configure the
CAD base services. You can run the utility again later to change your configuration
settings.
The CAD Configuration Setup utility consists of a series of nodes that require you to
enter data. You must complete all of the nodes in the utility to configure and to run the
CAD base services successfully.
enter data. You must complete all of the nodes in the utility to configure and to run the
CAD base services successfully.
IMPORTANT: While running the CAD Configuration Setup utility you
might see a dialog that says “Please wait...”. If this appears, you must
wait for the dialog to finish. If you try to click on the main CAD
Configuration Setup utility window, you might receive a notification
from Windows that the application is not responding. This is expected
behavior. The process should finish within 5 minutes.
might see a dialog that says “Please wait...”. If this appears, you must
wait for the dialog to finish. If you try to click on the main CAD
Configuration Setup utility window, you might receive a notification
from Windows that the application is not responding. This is expected
behavior. The process should finish within 5 minutes.
The nodes that appear when you run this utility depend on the following factors:
■
The host computer on which you launched the CAD Configuration Setup utility
■
If you are running the CAD Configuration Setup utility for the first time or if you
are running it again to change your configuration settings
are running it again to change your configuration settings
■
The services and applications that are running on the computer on which you
launched the CAD Configuration Setup utility
launched the CAD Configuration Setup utility
lists all of the steps that are part of the CAD Configuration Setup utility in
alphabetical order. For each step, the table indicates whether that step appears when
the CAD Configuration Setup utility is run on the computer that hosts the named
application or service. If you need to change a configuration setting, use the table to
determine the computer on which you must run the CAD Configuration Setup utility.
the CAD Configuration Setup utility is run on the computer that hosts the named
application or service. If you need to change a configuration setting, use the table to
determine the computer on which you must run the CAD Configuration Setup utility.
The table has the following columns:
■
Node Title: The name of the node
■
Situation: When the node appears
— Both: The node appears when you run the CAD Configuration Setup utility
for the first time and also when you run it again to change your
configuration settings.
configuration settings.
— Update: The node appears only when you run the CAD Configuration
Setup utility again to change your configuration settings.
■
Base: The computer on which the CAD base services run
■
VoIP: The computer on which the VoIP Monitor service runs
■
Rec: The computer on which the Recording and Statistics service runs