Cisco Cisco Application Extension Platform for SRE
Cisco Application eXtension Platform 1.0 Quick Start Guide
Configuring the Router
4
Cisco Application eXtension Platform 1.0 Quick Start Guide
OL-15669-01
Installation
To install the Cisco 280x ISR and Cisco AXP service module, see the platform-specific hardware
installation and configuration guides available on Cisco.com. For example, see the hardware guides
listed in
installation and configuration guides available on Cisco.com. For example, see the hardware guides
listed in
Configuring the Router
To configure the Cisco 280x ISR, perform the following steps.
Step 1
Open a Telnet session.
For the telnet session, use one of the following methods:
•
DOS window
•
Secure shell
•
Telnet/SSH client emulation software such as PuTTY
a.
Specify the IP address of the Cisco 280x ISR.
telnet
ip-address
b.
Type your username and password for the Cisco 280x ISR.
Example:
telnet 192.168.1.39
<enter>
Trying 192.168.1.39 ... Open
…..
User Access Verification
Username: cisco <enter>
Password: cisco <enter>
2800_w_axp#
c.
The # sign signifies that you are in enable mode, which allows you more privileges in the
Cisco 280x ISR environment.
Cisco 280x ISR environment.
d.
If you see a > sign instead of the # sign, type the enable command, followed by the
ISR-enable-password:
ISR-enable-password:
2800_w_axp> enable <enter>
Password: ISR-enable-password <enter>
2800_w_axp#
Step 2
Verify the running configuration.
Check the running configuration using the show running-config command. The output shown here is
from the running configuration shown in the
from the running configuration shown in the
.
2800_axp# show running-config
!
!
interface FastEthernet0/0
shutdown
no mop enabled
!
interface FastEthernet0/1
ip address 192.168.1.39 255.255.255.0