Cisco Cisco Firepower Management Center 2000

Firepower System Release Notes

Resolved Issues

 



Resolved an issue where, if you created a passive zone on a Firepower 8000 Series device and performed the 

show fastpath-rules

 CLI command, the system reported intrusion rules as inactive. (CSCut32479)



Improved the reliability of backup and restore. (CSCut34456)



The system generates a 

Having Inspect traffic during policy apply disabled may cause network 

disruptions until deployment completes

 warning if you deploy without enabling 

. 

(CSCut36078)



Resolved an issue where, if you created a file policy configured to 

, the system experienced 

issues and stopped processing traffic. (CSCut39253, CSCuu14892)



Resolved an issue where, if you selected one or more cells of the Original Client IP column in the intrusion 
events table view to review or copy, the system generated an error and did not display the rows you selected. 
(CSCut41458)



Resolved an issue where the system experienced latency and did not match traffic if you created an access 
control rule targeting users in an LDAP group that contains a large number of access-controlled users. 
(CSCut56233)



Resolved an issue where, if you created and edited a search for generated events, then canceled it before the 
search started, the system redirected you to the events page related to the search with the incorrect search 
name. (CSCut63265)



Improved disk manager functionality. (CSCut65740)



Resolved an issue where the system experienced issues if the last entry in the map list was a duplicate. 
(CSCut65738)



Resolved an issue where importing intrusion rule updates caused system issues. (CSCut65772)



Resolved an issue where, in some cases, the system dropped database communication and experienced 
errors. (CSCut71816)



Resolved an issue where, in some cases, deploying on a Firepower Management Center with registered 
Firepower 7000 Series and 8000 Series devices in a high-availability pair caused a fail over. (CSCut72278)



Improved health alert notifications for Cloud Lookup failures. (CSCut77594)



Resolved an issue where, if your system experienced two sequential failures, the system was placed into 
bypass mode even if you did not enable bypass mode. (CSCut80892)



Resolved an issue where the message column of the Retrospective Malware Events table view did not include 
the old disposition or the new disposition values of a retrospective malware event. (CSCut83512)



Resolved an issue where, if you restarted your ASA 5585-X device with a large number of subinterfaces 
configured without also restarting the SFR5585-X service card, the SFR5585-X service card appeared to fail. 
(CSCut89619)



Resolved an issue where using the 

show managers

 CLI command on a device registered to a system with 

multiple interfaces configured caused the system displayed the incorrect IP address. (CSCut95947)



Resolved an issue where, in some cases, update failure did not get caught in time. (CSCuu01055)



Resolved an issue where, if you experienced system issues, the cloud continuously checked for a new update. 
(CSCuu04844)



Resolved an issue where, if you created an access control policy with a URL category condition and the 
network map failed to load a complete database, the system experienced issues. (CSCuu06714)



Resolved an issue where the vulnerability database (VDB) install took an unexpectedly long time. 
(CSCuu06786)



Resolved an issue where, in some cases, your Firepower Management Center stopped receiving health events 
from a registered device. (CSCuu18450)