Cisco Cisco IOS Software Release 12.0(2a)T1 トラブルシューティングガイド
ROMmon Recovery Procedure for the Cisco 1000
Series Router
Series Router
Document ID: 15075
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Procedure
Related Information
Prerequisites
Requirements
Components Used
Conventions
Procedure
Related Information
Introduction
This page explains how to recover a Cisco 1000 Series Router stuck in ROMmon (
rommon # >
prompt).
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the hardware version below:
Cisco 1000 Series Router
•
The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
devices used in this document started with a cleared (default) configuration. If you are working in a live
network, ensure that you understand the potential impact of any command before using it.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Procedure
Follow the instructions below to perform ROMmon recovery:
Issue the dev command to see which devices are available on your router:
rommon 1 > dev
Devices in device table:
id name
eprom: eprom
flash: PCMCIA slot 1
rommon 2 >
1.