Cisco Cisco Content Security Management Appliance M1070 ユーザーガイド
2-9
AsyncOS 9.6 for Cisco Content Security Management Appliances User Guide
Chapter 2 Setup, Installation, and Basic Configuration
Running the System Setup Wizard
•
Notification settings and AutoSupport
•
System time settings
•
Admin password
Step 4
•
Hostname of the appliance
•
IP address, network mask, and gateway of the appliance
•
Default router and DNS settings
Step 5
Proceed through the wizard pages, and carefully review your configuration at step 4. You can return to
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
a step by clicking Previous. At the end of the process, the wizard prompts you to commit the changes
that you have made. Most changes do not take effect until you commit them.
Step 6
Launch the System Setup Wizard
To launch the wizard, log in to the GUI as described in the
. The first time you log in to the GUI, the initial page of the System Setup Wizard appears by
default. You can also access the System Setup Wizard from the System Administration menu
(Management Appliance > System Administration > System Setup Wizard).
(Management Appliance > System Administration > System Setup Wizard).
Review the End User License Agreement
Begin by reading the license agreement. After you have read and agreed to the license agreement, select
the check box indicating that you agree, and then click Begin Setup to proceed.
the check box indicating that you agree, and then click Begin Setup to proceed.
Configure the System Settings
Entering an Email Address for System Alerts
AsyncOS sends alert messages through email if there is a system error that requires your intervention.
Enter the email address (or addresses) where the alerts are sent.
Enter the email address (or addresses) where the alerts are sent.
You need to add at least one email address for the system alerts. Separate multiple addresses with
commas. The email addresses that you enter initially receive all types of alerts at all levels. You can
customize the alert configuration later. For more information, see the
commas. The email addresses that you enter initially receive all types of alerts at all levels. You can
customize the alert configuration later. For more information, see the
Setting the Time
Set the time zone on the Security Management appliance so that timestamps in reports, message headers
and log files are correct. Use the drop-down menus to locate your time zone or to define the time zone
by GMT offset.
and log files are correct. Use the drop-down menus to locate your time zone or to define the time zone
by GMT offset.
You can set the system clock time manually, but Cisco recommends using an Network Time Protocol
(NTP) server to synchronize time with other servers on your network or the Internet. By default, the
Cisco NTP server (time.sco.cisco.com) is added as an entry to synchronize the time on your content
security appliance. Enter the hostname of the NTP server, and click Add Entry to configure an
(NTP) server to synchronize time with other servers on your network or the Internet. By default, the
Cisco NTP server (time.sco.cisco.com) is added as an entry to synchronize the time on your content
security appliance. Enter the hostname of the NTP server, and click Add Entry to configure an