Cisco Cisco MDS 9000 SAN-OS Software Release 1.0
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
10
Cisco MDS 9000 Family Release Notes for Storage Services Interface Image Release 5.0(4k)
OL-22148-06
Related Documentation
Resolved Caveats
•
CSCtk60509
Symptom: The SANTap data path processor (DPP) may cause CRC errors in a multiple front-end
or back-end VSAN configuration with a heavy I/O load.
or back-end VSAN configuration with a heavy I/O load.
Conditions: This symptom might be seen when SANTap is running on a Cisco MDS 9000
MSM-18/4 module or Cisco MDS 9222i module with a multiple front-end or back-end VSAN
configuration, and there is a heavy I/O load on both VSANs.
MSM-18/4 module or Cisco MDS 9222i module with a multiple front-end or back-end VSAN
configuration, and there is a heavy I/O load on both VSANs.
Workaround: This issue is resolved.
•
CSCto09131
Symptom: The DPP fails, which causes the Cisco MDS 9000 MSM-18/4 module to reload.
Conditions: This symptom might be seen when ports flap on the RecoverPoint Appliance.
Workaround: This issue is resolved.
Open Caveats
•
CSCti56186
Symptom: Following a successful upgrade of the SSI image on a Cisco MDS 9000 MSM-18/4
module where SANTap is enabled, SANTap may go into an unknown state.
module where SANTap is enabled, SANTap may go into an unknown state.
Workaround: After the upgrade is completely finished, manually reload the Cisco MDS MSM-18/4
module to recover from the unknown state.
module to recover from the unknown state.
•
CSCti60854
Symptom: When you enter the system default switchport shutdown command, all iSAPI ports go
down.
down.
Workaround: None.
•
CSCtj37367
Symptom: If SANTap is configured on multiple modules on a switch and one of the modules is not
provisioned, the SANTap Prevent Downgrade Capability is removed for the entire setup.
provisioned, the SANTap Prevent Downgrade Capability is removed for the entire setup.
This symptom might be seen when more than one module in the switch is configured with SANTap
and the configuration is removed from one of these modules. SANTap does not check for the
presence of other modules before removing the capability.
and the configuration is removed from one of these modules. SANTap does not check for the
presence of other modules before removing the capability.
Workaround: None.
Related Documentation
The documentation set for NX-OS for the Cisco MDS 9000 Family includes the following documents.
To find a document online, access the following web site:
To find a document online, access the following web site:
The documentation set for Cisco Fabric Manager appears in the Cisco Fabric Manager Release Notes
for Release 5.0(1a), which is available from the following website:
for Release 5.0(1a), which is available from the following website: