Cisco Cisco IOS Software Release 12.0 S
2320
Cross-Platform Release Notes for Cisco IOS Release 12.0S
OL-1617-14 Rev. Q0
Resolved Caveats—Cisco IOS Release 12.0(16)S
•
CSCdt36569
When a multilink bundle is flapped under heavy traffic, there may be “output stuck” conditions on
some of the member links of the bundle. There is no workaround.
some of the member links of the bundle. There is no workaround.
•
CSCdt37135
Under very high traffic conditions, the Gigabit interface on a Cisco 7200 series router may stop
transmitting packets, and the output queue remains stuck at 40/40.
transmitting packets, and the output queue remains stuck at 40/40.
Workaround: Enter the clear interface gigabit x/0 command or the shutdown command followed
by the no shutdown command.
by the no shutdown command.
•
CSCdt37629
A Cisco Versatile Interface Processor 2-50 (VIP2-50) or VIP4-80 may reload under the following
conditions:
conditions:
–
There is an MC-T3 or MC-2T3+ port adapter in one slot of the VIP.
–
Traffic is sent through the port adapter at close to the line rate.
There is no workaround.
•
CSCdt38104
Removing side A of a DPT48 node removes the whole node from the Dynamic Packet Transport
(DPT) ring. The normal behavior should be that the DPT node should be able to work in wrap mode
with just one card. This functionality functions properly when the side B card of a DPT48 node is
removed, and the side A functions by itself. However, if the side B card is not taken out of the
backplane and the card A is removed, the DPT node no longer functions properly and cannot
continue its functionality in a wrapped state. There is no workaround.
(DPT) ring. The normal behavior should be that the DPT node should be able to work in wrap mode
with just one card. This functionality functions properly when the side B card of a DPT48 node is
removed, and the side A functions by itself. However, if the side B card is not taken out of the
backplane and the card A is removed, the DPT node no longer functions properly and cannot
continue its functionality in a wrapped state. There is no workaround.
•
CSCdt39968
A Cisco router may reload with a bus error after the snmp-server enable traps atm pvc global
configuration command is entered. There is no workaround.
configuration command is entered. There is no workaround.
•
CSCdt40483
On a Cisco 12000 series Internet router that is running Cisco IOS Release 12.0(13)S or 12.0(14)S
with Engine 0 line cards, Simple Network Management Protocol (SNMP) counters (for example,
ifOutOctets/ifHCOutOctets) may actually decrement. The counters usually decrement for no longer
than 10 seconds. This situation may cause difficulties in polling these SNMP counters more
frequently.
with Engine 0 line cards, Simple Network Management Protocol (SNMP) counters (for example,
ifOutOctets/ifHCOutOctets) may actually decrement. The counters usually decrement for no longer
than 10 seconds. This situation may cause difficulties in polling these SNMP counters more
frequently.
Workaround: Extend the polling period for SNMP counters.
•
CSCdt44367
When output Per Interface Rate Control (PIRC) is configured on a 3-Port Gigabit Ethernet line card,
multicast traffic that is going out this line card does not get rate limited. There is no workaround.
multicast traffic that is going out this line card does not get rate limited. There is no workaround.
•
CSCdt45094
A Cisco Gigabit Route Processor (GRP) may reload in a loop after failover because of memory
corruption. This situation occurs when there are two GRPs. There is no workaround.
corruption. This situation occurs when there are two GRPs. There is no workaround.
•
CSCdt46380
A Versatile Interface Processor (VIP) on a Cisco 7500/RSP series router that is running Cisco IOS
Release 12.1(5a)E4 may reload with the following error message:
Release 12.1(5a)E4 may reload with the following error message:
%ALIGN-1-FATAL: Illegal access to a low address
This situation has only been observed on Frame Relay interfaces with distributed Quality of Service
(QoS) enabled. There is no workaround.
(QoS) enabled. There is no workaround.