Cisco Cisco IOS Software Release 12.4(4)T

ページ / 314
1248
Caveats for Cisco IOS Release 12.4T
OL-8003-09 Rev. Z0
  Resolved Caveats—Cisco IOS Release 12.4(6)T3
Extended Register Values (XR4..XR1) = 00, CC, 50, 11 
4) Following is an example of output for FXS and analog E&M modules that indicates that the 
symptom has occurred.
Values read from PEB2x65 Codec connected to DSP 0, channel 1: 
------------------------------------------------------------ 
Extended Register Values (XR4..XR1) = D001, B83C, 3FF1, 63AC
CSCse17317
Symptoms: A router may during an E1R2 test for different country codes and codecs.
Conditions: This symptom is observed on a Cisco router only when E1R2 digital semi-compelled 
signaling is used.
Workaround: There is no workaround. 
Wide-Area Networking
CSCek28604
Symptoms: A Cisco device may reload (“System returned to ROM”) unexpectedly due to a memory 
leak in the ISDN L2 process.
Conditions: This symptom is observed on a Cisco device that functions in a call manager-backhaul 
configuration after running under stress for about 24 hours.
The output of the show processes memory, collected in regular intervals shows a memory leak in 
the ISDN L2 process. The amount of memory that is held by the ISDN L2 process will be very large 
and growing.
Workaround: Enter the isdn k 1 command on all backhauled serial interfaces.
CSCek31660
Symptoms: For VPDN sessions that are established with a LAC, the RADIUS progress code in the 
Stop record may be different from the RADIUS progress code in the Start record.
Condition: This symptom is observed on a Cisco platform such as a Cisco AS5400 that runs 
Cisco IOS Release 12.4.(3a) but may also affect Release 12.4T.
Workaround: There is no workaround. 
CSCek40618
Symptoms: A router may crash by address error (load or instruction fetch) exception during normal 
operation.
Conditions: This symptom has been observed when the router is configured with VPDN and 
Multilink PPP, using Virtual-Template interfaces.
Workaround: There is no workaround. 
CSCsc30497
Symptoms: NAS-Port Pre-Auth failure breaks PPPoE session limit per VLAN. Once the 
authorization fails, local limit does not get applied to a particular interface.
Conditions: This symptom is observed in Cisco IOS Release 12.3YM.