Cisco Cisco IOS Software Release 12.4(2)XB6 テクニカルリファレンス
-111
Book Title
OL-14681-01
Chapter Cisco Broadband Wireless Gateway 1.1 Command Reference, IOS Release 12.4(15)XL2
reference-point r6
reference-point r6
To configure various R6 parameters, including keepalive, base station path and response configuration
commands, use the reference-point r6 subcommand in base station group configuration submode. Use
the no form of the command to disable these parameters.
commands, use the reference-point r6 subcommand in base station group configuration submode. Use
the no form of the command to disable these parameters.
reference-point r6 [keepalive | path {purge-timeout value} | response]
no reference-point r6
Syntax Description
Defaults
The timeout value is measured in minutes. If the purge timer is not configured, the default value is 24
hours.
hours.
Command Modes
Base station group configuration submode.
Command History
Examples
The following example illustrates how to configure the reference-point r6 command, and sets a purge-
timeout value of 30 minutes:
timeout value of 30 minutes:
router(config)#wimax agw base-station group default
router(config-wimax-agw-bs)#reference-point r6 ?
keepalive Enable AGW-BS keepalive feature
path WiMAX AGW BS R6 reference point base station path
response WiMAX AGW BS R6 reference point response configuration commands
router(config-wimax-agw-bs)#reference-point r6 path ?
purge-timeout WiMAX AGW BS R6 reference point path purge timeout
router(config-wimax-agw-bs)#reference-point r6 path purge-timeout ?
<1-4320> WiMAX AGW BS R6 reference point path purge timeout in minutes
router(config-wimax-agw-bs)#reference-point r6 path purge-timeout 30
keepalive
Enables the BWG-BS keepalive feature.
path
Specifies the WiMAX BWG BS R6 reference point base station path.
purge-timeout value
Specifies WiMAX BWG BS R6 reference point path purge timeout value. As
soon as the last session associated with the BS path goes away, the path purge
timer is started to remove the path after the timer expiry.
soon as the last session associated with the BS path goes away, the path purge
timer is started to remove the path after the timer expiry.
The timeout value is measured in minutes. If the purge timer is not
configured, the default value is 24 hours.
configured, the default value is 24 hours.
response
Enables WiMAX BWG BS R6 reference point response configuration
commands.
commands.
Release
Modification
12.4(15)XL
This command was introduced.