Cisco Cisco IOS Software Release 12.4(2)XB6 テクニカルリファレンス

To display subscriber information, use the show wimax agw subscriber command in privileged EXEC 
mode. If the subscriber macid is not specified, the output displays information about all the subscribers 
currently connected to the BWG.

show wimax agw subscriber [msid macid] [bsid] [brief {flow | host | session | traffic}]

No default behavior or values.

Privileged EXEC. 

The following information will be displayed for each subscriber.

Subscriber MACID

Local/remote IP addresses of the signaling end points for this subscriber

Local/remote UDP ports of the signaling end points for this subscriber

Subscriber FSM information

Number of flows currently active

Displays information about the mobile subscriber.

If the subscriber macid is not specified, the output displays information 
about all the subscribers currently connected to the BWG.

Displays output that contains a list of all the subscribers currently connected. 
Contains the following information:

Subscriber MACID

Local/remote IP addresses of the signaling end points for this subscriber

Local/remote UDP ports of the signaling end points for this subscriber

Number of flows currently active

Displays brief output related to flows.

Displays brief output related to the host.

Displays brief output related to sessions.

Displays brief output related to traffic.

When bsid is specified, it only displays the subscribers related to the BS. 
msid and bsid are mutually exclusive.

12.4(15)XL

This command was introduced.